Everything You Need to Know to Install Galvanized Conduit

Galvanized conduit is an affordable, versatile and durable material used to protect and route the wiring of electrical systems. It is an ideal option for both commercial and residential applications because of its high corrosion resistance and long life span. In this article, we will go through the process of installing galvanized conduit so that you can get started with your electrical project.

Gather the Necessary Materials

The first step in installing galvanized conduit is gathering all the materials you will need. This includes the conduit itself, the appropriate connectors, mounting hardware, and any other additional fittings or supplies that may be necessary for your setup. Once you have everything you need, make sure to take proper safety precautions before beginning the installation to avoid any potential hazards.

Cut the Conduit to Size

Once you have your materials, it’s time to start installing the galvanized conduit. The first step in the process is to measure and mark where each section of the conduit will be installed. After this is done, use a hacksaw or power saw to cut the conduit to size. Make sure the marks are made on the correct side of the conduit (the pull-head side) to ensure that the installer has enough space to properly pull in the wire later on.

Drill Holes for Mounting

Once you have the conduit cut to size, you will need to drill holes for the mounting hardware to hold it in place. The size and number of holes will depend on the type of mounting hardware being used, and the size of the conduit. When drilling, make sure to use the appropriate drill bit for the mounting hardware and the type of wall or ceiling you are mounting onto.

Install the Stainless Steel Straps and Electrical Boxes

Next, the stainless steel straps should be installed to secure the conduit to the wall or ceiling. After this, the electrical boxes should be installed at the designated entry and exit points. Make sure that all the screws and clamps are securely tightened and that the wires can be pulled through without obstruction.

Attach the Connectors and Pull the Wire

Now it is time to attach the connectors to secure the wire runs. Securely attach the connectors using the appropriate tools and make sure that they are fastened properly. Once the connectors are attached, you can then start pulling the wire through the conduit. Depending on the size of the conduit and the amount of wire being pulled through, the pulling can be done manually or with a hand-powered wire pulling machine.

Secure the Cover Plates and Test

The final step in installing galvanized conduit is to secure the cover plates. Make sure that all the wiring is properly connected and that the cover plates are securely mounted. Finally, perform a final test to make sure that everything is running as it should. With the installation complete, you are now ready to begin using your new electrical system.