How To Install A Plug With 3 Wires

Installing a plug with 3 wires can seem daunting for the uninitiated. But luckily, armed with just a few tools, it's a relatively straightforward process that anyone can do! This article will walk you through the steps needed to install a plug with 3 wires, from preparing the plug, straightening out any knots in the wiring and connecting it all up to the switch or socket.

Before you get started, it's important to make sure you have all the necessary parts and tools. You'll need a set of electrical pliers, screwdriver, two-strand wire and a three-wire plug. Additionally, you may need a voltage tester and protective gloves. Once you have everything you need, it's time to get started.

Straightening Out The Wires

The first step is to straighten out any knots in the wiring. Take your electrical pliers, then carefully pull the knotted area of the wire to separate it from the rest. Once you have straightened out all the wires, use your voltage tester to check for any current running through the wiring. If there is none, then you're good to go.

Connecting The Plug To The Switch Or Socket

Now it's time to start connecting the plug. Do this by inserting the two-strand wire into the plug. Make sure to leave enough slack on each end so the wire doesn't pull out. Secure the two-strand wire in place by twisting the two prongs of the plug together. Once this is done, you can connect the three-strand wire to the switch or socket. Start by connecting the red wire, then the black wire and lastly the white wire.

Testing The Connection

Finally, you can test the connection by switching on the circuit breaker. If the new plug works, congratulations! You've successfully installed a plug with 3 wires. If not, then you may need to disconnect the plug and start again. Make sure to always wear protective gloves when dealing with electrics.

Wire An Outlet